We have (2) NetMetal 5 with 30db Dish, version 6.44.3 software.
AP Config:
Bridge
5Ghz-A/N/AC
20/40/80Mhz eeeC
5805
Protocol = any
Installation = outdoor
STA Config:
Everything the same except Frequency is set to “auto”
Situation:
Signal TX/RX -59/-60
CCQ TX/RX 74/80
When a load is applied (running bandwidth test) the CCQ will start out good then gradually drop all the way to 5% or worse.
We have tried different channel width and frequencies and protocol, all do the same thing.. Any help would be greatly appreciated.