LMT LTE18 and Capsman configuration

Hardware MikroTik hardware general
1

Just recently got from LMT latest Mikrotik LTE18, can’t configure Capsman to support existings devices.

Currently have three CAPS - two HAP ac lite and one HAP ac2, all running 6.47.2 version.
CapsMan was configured on HEX also version 6.47.

When transfered all configurations to LTE18, no CAPS connecting to the new manager, neither legacy v6 devices, neither new CAP on the LTE18

LTE18 running specific version 7.0, currently no legit upgrades proposed, when press Check Updates - there message - ERROR: file not found.

When reset configurations it is not possible to clear config - it is always loading preset with active both WLANS (2.4 and 5Ghz) and preset passwords (stated on the router itself).

Is anyone also have similar setup ? Reviewing forum - it is not 100% clear is CapsMan working at all with v7, some sources stating it is included, other state opposite, and third point - it is included but have some issues (bugs).

2

Try this, then post your v7 capsman config:

https://download.mikrotik.com/routeros/7.1beta2/routeros-7.1beta2-arm.npk

3

if i will make softwar update to 7.1beta → how can I then downgrade back to 7.0 ? :wink: Just afraid a little bit :wink:

I actually got v7 Capsman working with internal CAP so far, old ones not connecting at all.

Maybe there some way to troubleshoot it ? like error when then try to provision themselves ?

4

In Log on the CAP there constantly same error:
CAP connect to LMT LTE18 (::ffff:192.168.8.1:5246) failed: handshake failed: error 140870e8 (6)

CAP is reset to defaults - with CAP mode.
Looks like some certs cannot be found.

5

Case is SOLVED - I put in CapsMan Manager the folloing settings :

Certificate > auto
CA Certificate > auto

After a second Capsman also started to show names of generated certificates and old CAPS now connecting normally!

Will check stability for a while!