Low throughput on wds

RouterOS Beginner Basics
1

Hi

I am have set up a RH411 and two RB751 in ap brigde / WDS / Static mesh and I have tried all kind of different combinations, but not able to reach more than 10 -15 mbps throughput. Current configuration is N-only / 2472 MHz / 20/40 MHz HT below. In theory I think this should be able to give at least 100 mbps. Signal is good overall Tx CCQ 48%, noise floor is 103 dBm.

Does these numbers look good - or is there something with the signal that is not OK?

Thanks,

Pilgrim

2

hello
your CCQ is low.try to get better signal (for example change TX power)
i think you cant get 100mbps throughput when using wds because CSMA/CA is working and decrease your wireless throughput.
for getting best throughput , check you HT chains (enable all of them) and check MCS (enable just 14 and 15 MCS in supported and basic)