[LTE] - Quectel EM06 & IP Passthrough support?

[stevenma]

Hello

I only wanted to ask if the Quectel EM06 LTE modem are fully supported (AT commands, LTE monitor,…) by RouterOS 6 or v7 and if it also support IP Passthrough?

(I know there is support for the EP06 but I haven’t found any info about the EM06 although it’s exactly the same electronic on board it’s only a M.2 instead of MiniPCIe format)

Thank you

Hi @Acryli,

I came here to ask the same question. I do have an EP06-E (firmware rev. EP06ELAR03A07M4G) running successfully for several days under RouterOS 7.1beta2 in a MikroTik LHG R dish and router.

I used these links to get the EP06 LTE working, although in the log I have: ppp-out1, initializing, resetting link, =could not acquire serial port, disconnected. Repeat… I also don’t have EP06 carrier aggregation (Bands 3 & 20 on UK Three network ) working although I’ve seen CA working with this combo on the same tower with a Huawei B525.
https://wiki.mikrotik.com/wiki/Cellular_Quectel_modems_01
http://forum.mikrotik.com/t/quectel-ep06-e-and-wap-r-ac-rbwapgr-5hacd2hnd/131724/9

I haven’t attempted this yet:
https://wiki.mikrotik.com/wiki/Manual:Interface/LTE#Passthrough_Example
mainly as I’m not sure if it’s intended for the Quectel modems and I don’t want to break my setup as I’m still learning.

You might want to change the title of your thread to include EP06 instead as it might get a bit more attention.

Let’s hope there are some more replies to this thread.

Steve