Master Port Problem on RB750

RouterOS Beginner Basics
1

Do you have the same problem?

  • Yes
  • No
  • I haven’t tried yet
0 voters

As it is possible to RB750G to remove the default settings and set the ether1 to master port of the rest ehter ports, I couldn’t do so in RB750. I wonder why?

2

Only ether2-ether5 can be switched on RB750.

3

Hello,

I wonder if all 5 ports are equally configurable on a RB750?

I have a feeling that ether5 has some problems (5.0rc7) as PPPoE is configurable but does not work as well as ether5 can not act as local master nor as a DHCP server port.
The same configuration on ether3 works perfect.

Regards,
Z

4

I looked up “rb750.pdf” on routerboard.com and the line below is written in it.

Ethernet: Five 10/100 ethernet ports (with switch chip)

5

yes, all 5 ports are equally configurable on a RB750.

the ether1 port can’t be switch master, that’s the only limitation. you can put any config on the ether5 port.

6

Is it possible to set ether5 to Master and the rest to slave of ether5?

7

Please send this report to support@mikrotik.com along with supout.rif file from the router.