Maximam Distance for Point to Point transperent Bridge

RouterOS Wireless Networking
1

Dears ..

I have the following hardware :

2 RB433AH , 2 R52H and 2 antenna 20 dbi .

i have configure it as point to point transperent bridge .. can i know whats the maximam distance i can do it with this point to point link to geive best performance , lowest latency and maximam bandwidth transfer .


your urgent kind help is much appreciated .



Thanks and kind regards

2

What distance and speed do you actually need?
higher distance = lower speed.

3

fully extend your arms and measure the distance…that’s max. wireless link.

4

Max depends normaly for long ranges on the altitude ASL “above sea level” , also the signal should be in 60dbm-65dbm in both sides, and you will have a good speed, also use 5Ghz for long distances because of the smaller fresnel zone .

Greetings.

5

My dear ..

The Distance is 22 Km and i have 45 Mb full duplex , what i need to know is :

1- is the needs only 2 RB433AH , Antenna 20 dbi and R52H on the two nodes only or i need to put more repeaters in the line of sight ?

2- is using one RB433AH enough to carry 45 Mb full duplex or i have to share thi BW between tow or three devices ?



please note the twore hight is 70 M on the AP side and 35 M on the clinte side .

Thanks