Hi guys, I have a working RB750Gr3 hEX router with two VLANs and a PPoE server. This hardware is getting old and, moreover, I am expecting to switch to a fibre connection in the near future. Thus, I have decided to buy a successor to the old HEX router. I bought the HEX S (E60iUGS) and am trying to…

Well, the L009 is actually a lot slower than a hex S, at least in the usual test results metric we use to approximate the real world performance, the 512 bytes packet/25 firewall filter rules: Hex S (2025): 498.1 Mbps L009: 323.6 Mbps In most (but not all) configurations, fasttrack will be used, …

Hmmm. [image] slv: pvid=1 [image] slv: vlan-ids=1 Rules of the Mikrotik Club: [image] The twelve Rules of Mikrotik Club Beginner Basics Preamble and disclaimer: The following is a set of Rules that are intended as advice useful to avoid the most…

Im not sure if still recommended but most people seem to avoid using ether1 for the WAN on that model. Also the safe and currently recommended version 7 firmware is 7.19.6

[image] slv: Here is the minimum start configuration – even this part is not working. We need more details. "not working" is too vague. e.g. "My car isn't working. What's wrong with it?" https://web.archive.org/web/20240115025942/https://forum.mikrotik.com/viewtopic.php?p=908118 https://w…

Do we have somewhere diagram how the physical ports are connected inside the RB760iGS? I only was able to find this diagram [image] In my example, the router is equipped with an EN7523, unlike the EN7562 in the screenshot above. Is it worse to use Eth1 directly connected to the CPU than to use …

@Buckeye In the meantime, I found this written example to be very helpful. It not only takes care of the core settings, like bridge, but also has settings for security. I’m trying to use it as a template now and adapt it to my needs — to build two VLAN interfaces and host some services. I will let y…

[image] slv: Is it worse to use Eth1 directly connected to the CPU than to use Eth2 as a WAN? When the device came out, people started reporting issues with the speed of ether1 as WAN. The temporary workaround was to use any of ether2-5 as WAN instead, but the issue was/is a software one so …

[image] slv: n my example, the router is equipped with an EN7523, unlike the EN7562 in the screenshot above. I think that the "switch" portion is the same in several SoC's See https://git.infobricfleet.com/gtu/openwrt/-/blob/v24.10.3/target/linux/airoha/en7523/target.mk So the "switch" is l…

[image] slv: Do we have somewhere diagram how the physical ports are connected inside the RB760iGS? This is the block diagram for the Original version of the HEX S (RB760iGS). It used different SoC and all RJ45 ports were connected "through" the switch. However, the "model" that anav was re…

Migration to HEX S (2025) - vlan's problems - help needed

RouterOS Beginner Basics

jaclaz December 7, 2025, 2:07pm 3

Hmmm.

Rules of the Mikrotik Club: