Mikrotik KNOT8Kit - loses LoRaWan settings after restart

RouterOS Beginner Basics
1

Hello,

I use the KNOT8Kit as a LoRaWAN gateway, connected via PoE to my networt-switch.

After every reboot ( Firmware-update ) or PowerCycle (e.g. when the network-switch reboots after an update), the KNOT8 loses the LoRaWAN settings.

LoRaWAN is deactivated and the target servers are deleted in the settings.
This means that I have to log in every time, enter the servers again and start LoRaWAN.

This is quite annoying because you don’t normally notice it.

Question:

Is this possibly a setting thing that I have to set a switch somewhere in the configuration so that LoRaWAN starts automatically after a reboot or is this a firmware bug?

Thanks in advance

Firmware is the lastet version, updated yesterday

2

No, that shouldn’t happen. Are you using the old lora extra package or the iot package?
Since 7.11 Lora is included in the iot package, so the old one is no longer needed. Mine came with ROS 7.0.5 and had both installed, try to remove the lora package if it exists, reboot and do the config in “IoT/LoRa”. Then reboot and check if the settings are kept.

3

I´ve had the same problem. After update to 7.13beta2 LoRaWAN starts automatically after a reboot