Mikrotik on Nokia IP130

RouterOS General
1

Hi,

I have successfully installed Mikrotik 2.0.41 on an IP130 with a 6 gig notebook drive.
I am stuck with the network drivers as I am prompted to load interface drivers during setup.
Below is a dump of what the Nokia operating system thinks the network cards are.

fxp0 <Intel EtherExpress Pro 10/100B Ethernet> rev 16 int a irq 6 slot 1
netlog:eth-s1p1 .. Ethernet address 0:a0:8e:21:cb:f4
fxp1 <Intel EtherExpress Pro 10/100B Ethernet> rev 16 int a irq 10 slot 2
netlog:eth-s2p1 .. Ethernet address 0:a0:8e:21:cb:f5
fxp2 <Intel EtherExpress Pro 10/100B Ethernet> rev 16 int a irq 11 slot 3
netlog:eth-s3p1 .. Ethernet address 0:a0:8e:21:cb:f6

I see this driver is supported in Mikrotik so would anyone have an idea what the problem could be?

Thanks

2

More info…

[admin@MikroTik] > /system resource io print
PORT-RANGE OWNER
0x20-0x3F APIC
0x40-0x43 [timer0]
0x50-0x53 [timer1]
0x60-0x6F keyboard
0x70-0x7F [rtc]
0x80-0x8F DMA
0xA0-0xBF APIC
0xC0-0xDF DMA
0xF0-0xFF FPU
0x1F0-0x1F7 IDE 1
0x2F8-0x2FF serial port
0x3D4-0x3D5 [cga]
0x3F6-0x3F6 IDE 1
0x3F8-0x3FF serial port
0xCF8-0xCFF [PCI conf1]
0x8000-0x803F Intel Corporation 8255xER/82551IT Fast Ethernet Controller
0x8400-0x843F Intel Corporation 8255xER/82551IT Fast Ethernet Controller
0x8800-0x883F Intel Corporation 8255xER/82551IT Fast Ethernet Controller
0xFC00-0xFC0F Cyrix Corporation 5530 IDE [Kahlua]
0xFC00-0xFC07 IDE 1
0xFC08-0xFC0F IDE 2

3

you should send a supout.rif file to support

4

Thanks Normis… I have sent file