mikrotik routerboard 411/411r

RouterOS General
1

Hi

I have little problem with my mikrotik routerboard 411,
I use winbox..
from wireless table I associated my wireless antenna Mikrotik (station mode) with the access point, If I use a ping-tools (wlan interface) I can ping the access point in 3ms perfect!
But If I ping the Access Point with ping-tools (ethernet interface) I cannot ping the Access point, and from my PC I can ping ethernet interface, but I cannot ping Wlan interface or Access Point!
How can I bridge wlan interface with ethernet interface?

for some test I have used:
wlan interface 192.168.1.x
ethernet interface 192.168.1.x
or
wlan 192.168.1.x
ethernet 192.168.1.x
bridge 192.168..1.x
or
wlan 192.168.1.x
bridge 192.168.1.x

but never I have comunicate from my pc to Access point!
:frowning:

May you help me?

2

Hi,

you need to:

create a bridge
add ether1 port
add wlan1 port
put an IP address to ether1 port

It will work : D!

3

ok I’ll try thanks a lot,
but on 411/411R I have only 1 port ethernet and 1 port wlan,
is it the same?

4

yes.

5

Works well :slight_smile:
thank you very very much

6

Perhaps my first karma vote?! ; D!

7

you should give him some karma points :slight_smile:

8

just done :slight_smile:

9

Thanks! Lets catch chupaka!

10

11

did I miss something here, or didn’t he say he was in station mode!! Yet he was addressing without NAT! using same subnets too!

Try pseudobridge mode.

Add bridge,

Add wlan1 port into bridge
Add ether1 port into bridge.

Give Bridge 1 IP address only in same subnet as your PC and /24

Add a sprinkling of sugar and bake in an oven at 250 degrees for half an hour!

Someone give me a vote so I can start to catch up with Chupaka!