MLPPP Bridge ? Extend public ip, possible or not ?

[jakubj]

Hi Everyone I’m new to the community but have worked with MT for sometime. I was wondering if anyone can help me with this setup or even if its possible.

Setup:
4 DSL bonded with MT RB750G when the PPPoE session is created the MT gets the public IP from the ISP. This has been working great for years we are looking to get an advanced UTM/Security appliance and the device doesn’t support MLPPP so I was wondering if there’s a way to tunnel or bridge/extend the public IP from the MT to the UTM/Security appliance ?

Any thought or suggestions would be appreciated.

Cheers!

Jakub

[jandafields]

@jakubj

Hi Everyone I’m new to the community but have worked with MT for sometime. I was wondering if anyone can help me with this setup or even if its possible.

Setup:
4 DSL bonded with MT RB750G when the PPPoE session is created the MT gets the public IP from the ISP. This has been working great for years we are looking to get an advanced UTM/Security appliance and the device doesn’t support MLPPP so I was wondering if there’s a way to tunnel or bridge/extend the public IP from the MT to the UTM/Security appliance ?

Any thought or suggestions would be appreciated.

Cheers!

Jakub

I don’t think you can have the public IP on both the MT and the UTM, but you can do this so all incoming traffic goes directly to the UTM:

/ip firewall nat add chain=dstnat in-interface=pppoe_dsl_connection action=dst-nat to-addresses=192.168.0.109