Need assistance in configuring 1100AH-X2 Router

RouterOS General
1

I need to configure several vlans on the router as well as NAT from one of the vlans, I “think” I have the vlan thing configured but i do not know how to NAT from one of those vlans.


My config is as follows

Cisco trunk —> BaseBox5 ------ PTP BRIDGE LINK ----- BaseBox5 -----> ether13 trunk on RB1100AH


I want ether1 as vlan 10, ether 2 as vlan 20 (already configured)

On ether1 I will connect some other AP’s for Clients to connect, I will probably enable the hotspot on it but i have no idea as to how to NAT from that interface.

I can ccess the router on the management vlan already, also ether2 is already configured with an IP in that vlan.


I really need help

Thanks.

2

Is there a reason that you chose Ether 13 as the trunk? If you used a different port you could then use the switch chip to generate some VLAN access ports.

3

There is no particular reason as to why I chose that port, what is the difference if I had used another port?