Hello all, I am quite new to MikroTik routers. I am preparing a new house setup. Network diagram I have now a few questions: How can have the dhcp servers tied to VLAN 101/102 in Router1? Should I have a supplementary VLAN for devices management? What configuration is necessary to have the tr…

Hi, welcome, Have you tried search funcionality of forum? For DHCP & VLAN [image]

This is the defacto bible on vlans........ [image] Using RouterOS to VLAN your network Useful user articles Title: Using RouterOS to VLAN your network Welcome: This article is for system integrators, network administrators, and product enthusiasts looking for the defini…

Thanks for the links. I have read them and (at least partially) understood the content. Till now, I have been able to translate these config to my case, up to one point: My ISP is not providing a fix IP, but a changing one, via DHCP. So I changed: Yellow WAN facing port with IP Address provided…

If you read the 12 rules, it should not be a question LOL, regarding posting the config.. /export file=anynameyouwish (minus router serial number, any public WANIP information, keys

Hi @anav , About the 12 rules, I am sorry, but I don't understand which one you see applicable to my case? Here is the config of the router: router_config.rsc (3.2 KB) And the config of the AP: ap_config.rsc (2.2 KB) Any hint will be appreciated. Thanks and regards, Jacques-D.

Yeah my bad I assumed jaclaz would have the importance of a. network diagram b. requirements c. post config but alas it fails, to help new posters in this regard.

Okay problem number one, you dont have a router at all. Its a switch and a weak one at that for any routing. THe methodology for setting it up probably by chip switch settings is probably best but I have no clue on that. I will set you up for traditional vlan setups on the bridge that will work bu…

First step is to take port off bridge ( remove from /interface bridge port ) Give it a name etherx name=OffBridge7, give it an IP address, add it to the trusted interface and then plug in laptop or computer to port 7, change IPV4 settings to 192.168.77.2 and then gain access (user name, passwo…

Hi @anav , Sorry for all the confusion. Port 8 of router is updated for local management. I have attached an updated network plan and configurations. router1.rsc (6.4 KB) ap11.rsc (4.7 KB) GH_net_diagram.pdf (72.4 KB) House is a 3 floors building, almost no wireless between the floors. Only 1…

So Switch2 has no settings and just lets everything go through to the CAPAC So in effect we trunk to switch2 and all the vlans should reach AP21??? Best for guarantees to always use managed switches. So same same for Switch1 then?? ++++++++++++++++++++++++++++++++++++++++++ # model = CRS112-8P…

network diagram questions

RouterOS Beginner Basics

anav August 20, 2025, 9:04pm 3

This is the defacto bible on vlans........

and have a read through this..............