The card could be detected from MikroTik, but the reboot after I enable it, it would hang the system, and after a hard reset then next time it won’t show up in interfaces.
I tried it with PC pentium 3, RB112, and WRAP boards, all of them acted the same way.
I tried it with 2.9.6, 2.9.7 and 2.9.23 versions of MikroTiK, same problem.
Is this a usual problem, do i need to upgrade the the boards BIOS, or it is a bad card and send it back for RMA???
I have those cards in rb112s and rb532s and I have not had any of them reboot or not show the card in the interface screen.
They just work!
Long history about this…
Check here…
http://forum.mikrotik.com/viewtopic.php?t=8042
Regards!
Alessio
I thought I spoke to soon this afternoon as I watched a RB112 reboot 3 times. But then I remembered that I had setup watch dog when I pre configed the unit at the office. LOL After I connected to the tower it was all good.
