Dear guys!
Today I have installed ver 5.7 of routerOS on one of my AP and on all CPE that are connect to this AP. Then I enabled NV2 protocol on AP and on CPE side I set wireless-protocol to any.
After that, traffic of AP goes down to 0 Kbps, all CCQ of link decrease from ~90% to 30%, TX/RX Rate goes down to 6Mbps and I can’t ping CPE even if they are connect to AP. Why? Could someone help me?
In AP side there isn’t any Noise Floor Treshold set, but in CPE side there is HW Protection mode set to “rts cts”
If I disabled NV2 protocol on AP, all come-back to normal (CCQ around 90%, TX/RX rate to 18 or 24 Mb, I can ping CPE, ecc).
Thanks in advance for help
Best regards