Hello,
Excused first my bad English.
I have a RouterBoard RB150 with L4 - 5 Ethernet Ports
I have enabled Bridge mode, Ethernet ports 2,3 and 4 are assigned to the bridge and the IP 192.168.0.1/24 assigned.
Hotspot and DHCP of the Bridge assigned.
Port1 is Uplink pppoe-out1
Port5 is for the Office, without Hotspot and has 192.168.5/24 as address.
At Port2 the Bridge the AccessPoint (Linksys WAP54) is put, the computer at the AP gets by DHCP all values suitably assigned.
My problem is that I do not have access with the Bridge to Internet.
Office PC at Port5 functions perfectly.
If I disable the bridge and assign the ip 192.168.0.1/24 to port2, and hotspot to port2, then the hotspots works without any problems, but then the office PC on port 5 can’t be reached any longer.
I would like to reach the following:
A. the Office (Port5) by NAT WITHOUT HotSpot into the Internet - > functions
B. the Office (Port5) in the HotSpot net, in order to be able to access the Aps - > no functions
C. the Public HotSpot net (Port2 or Bridge) in the Internet (NAT) - > no function
D. the Public HotSpot net (Port2 or Bridge) NOT in the Office LAN - > functioned - because of C.
I think it’s a Firewall problem, however my modest knowledge is not sufficient and I is dependent on your assistance.
A few pictures of the configuration I put down once under http://www.magickey.de/hotspot/.
Best thanks for your assistance.
Greeting