One to One NAT For Hotspot Not Working On V6?

RouterOS General
1

I have a hotspot running, just updated from v6 rc9 to v6 final.

I have an ip pool of public addresses that is handed out to my clients on authentication. However after the upgrade, whenever the IP Pool is set to anything other than “none” the client cannot access the internet after they login. On the Mikrotik it shows that the client is logged in, however the client cannot get to the internet.


Setting the Address Pool to “none” is the only way to have the client get online. Anyone else seeing this?

2

Same problem here too, once the user loged in reachability to status page is lost

3

Yep same again here all fine until login (can access walled garden sites fine pre login then nothing post login) :confused:

4

Same here..
when I disabled hotspot server, client can online normal like always, but, when enabled the hotspot server again, after login client can’t get online.

Using ROS v6 on X86. finally downgrade to v5.25 again.