Outbound connection to other Wan interface in same Microtik

RouterOS General
1

Hi,

I’m new in the world of Microtik. I have read a lots of them and it look very easy to use. But today, i have a issue with this.

I hosts a Website on other subnet in the same Microtik. The customer are not able to go on this website on other WAN IP address. I would like to do a outbound connection and go on the WAN Ip address of the website.

Is there any way ? :confused:

thank you for your help guys! :slight_smile:

2

It sounds like you may need Hairpin NAT. Check out this wiki page:

http://wiki.mikrotik.com/wiki/Hairpin_NAT

3

I tried the Hairspin NAT and it doesnt work.

My network Internal 172.16.100/24 would like to go out on eth12 on WAN interface, and go back in on Eth11 on WAN public address to reach the subnet 192.168.0.3 behind.

thanks

4

Can you post an export from your router?