Overclocking RB112

[F.J.S]

I used command:

/system routerboard settings set cpu-frequency=180MHz

I got

input does not match any value of cpu-frequency

What’s wrong?
I tested even 200MHz and 264MHz, everything same.
Only 175MHz accepted. Why?

It is RB112, RouterOS 2.9.28, firmware 1.14

[normis]

what do you get at the cpu-frequency= when you type TAB twice ?

[F.J.S]

@normis

what do you get at the cpu-frequency= when you type TAB twice ?

175MHz

[normis]

sorry, setting of this value only works on RB500 series

[stealth]

I setted RB112 to 200Mhz by adding 1khz resistor to R7 position and jumper on JP7. Works fine

[F.J.S]

@stealth

I setted RB112 to 200Mhz by adding 1khz resistor to R7 position and jumper on JP7. Works fine

Which transfer did you reach?

[stealth]

@F.J.S.

@stealth

I setted RB112 to 200Mhz by adding 1khz resistor to R7 position and jumper on JP7. Works fine

Which transfer did you reach?

Cant remember exactly, but it was about 14% increase.
Same graduality as on RB532.

[jarosoup]

@stealth

I setted RB112 to 200Mhz by adding 1khz resistor to R7 position and jumper on JP7. Works fine

Nice, thanks for sharing