Hello,
I try to config POE output on my hEX PoE lite having firmware v3.29 and OS v6.34.2 and using 24V external power supply.
I would like to power on two cam (one D-Link DCS-7010L connected on port 3 and other one Mobotix M12 connected on port 4). This cams support 802.3af POE protocol.
On Interface > Ethernet > POE
if set “auto on”, in the PoE Out status line I’m read “waiting for load” but also waiting for a few minutes the cameras does not turn on… 
If set “forced on”, in the spaces below it reads this:
PoE Out Current: 22 mA
PoE Out Voltage: 23.7 V
PoE Out Power: 0.5 W
but the cameras does not turn on!!
HELP PLEASE! 
There is some other configuration to be set?
Many thanks for your replies!
