I have a CCR1009-8G-1S-1S+ running 6.37.5 software release at a very remote location. I just had all of my active ports just bounce. Below is the section of the log showing the occurrence. Has anyone else had this issue? If you had this issue, what was your resolution? I have not seen this in any posts and I have not seen it in the release notes as a fix unless I missed it.
11:22:14 interface,info ether1 link down
11:22:14 interface,info ether2 link down
11:22:14 interface,info ether3 link down
11:22:14 route,ospf,info OSPFv2 neighbor X.X.X.X: state change from Full to Down
11:22:14 route,ospf,info OSPFv2 neighbor X.X.X.X: state change from Full to Down
11:22:15 interface,info ether2 link up (speed 100M, full duplex)
11:22:16 interface,info ether3 link up (speed 1G, full duplex)
11:22:17 interface,info ether1 link up (speed 1G, full duplex)
11:22:21 interface,info ether1 link down
11:22:21 interface,info ether2 link down
11:22:21 interface,info ether3 link down
11:22:21 interface,info ether6 link down
11:22:21 interface,info ether7 link down
11:22:21 interface,info ether8 link down
11:22:22 route,ospf,info OSPFv2 neighbor X.X.X.X: state change from Full to Down
11:22:22 interface,info ether7 link up (speed 10M, half duplex)
11:22:23 interface,info ether2 link up (speed 100M, full duplex)
11:22:23 interface,info ether3 link up (speed 1G, full duplex)
11:22:23 interface,info ether8 link up (speed 100M, full duplex)
11:22:24 interface,info ether1 link up (speed 1G, full duplex)
11:22:28 interface,info ether6 link up (speed 1G, full duplex)