Problem with system reset-configuration and winbox

RouterOS Beginner Basics
1

Hi,

I’m having problems accessing the router RB450G through winbox.

For testing, I enter the router using the serial port and through console commands I have executed the command “system reset-configuration” in order that the router is set to factory default, but now I can not access the router using the winbox, even I used the mac address but I can not access the router using the winbox

What am I doing wrong?

Thanks

2

It depends on which board and on which port you are trying to connect.
Some default configurations doe snot allow connection to WAN port.
See here for more details
http://wiki.mikrotik.com/wiki/Manual:Default_Configurations

3

Hi, I’m use the RB450G and I’m traying to connect to port Eth1, (192.168.88.1), in my PC the internet protocol properties is configured like this:

What am I doing wrong?

Thanks

4

system reset command probably erased the configuration the device came with.
you can try to connect to the router (make sure to use ports 2-5, not port 1) from your PC with Winbox. Click the […] button and Winbox will find the device. Click on the MAC address to connect. You will then be able to see the IP addresses of the device, and if they are removed, add them back.