PTP BETWEEN LHG5 AND DYNADISH 5

RouterOS Wireless Networking
1

Hi all,

I try to make PTP link between LHG5 and DYNADISH 5 but it doesn’t working. Any advice to give me.

PS: I use Dynadish like bridge( ap bridge not working due to ROS license level) and lhg5 like station bridge.

2

It should work. Did you ever make a link before?
Check that the wireless settings on each end are compatible.

3

Does you station-bridge see the the bridge through wireless scan?

4

Hi thanks for reply.

Yes i’ve already make a link on past. Between two same antenna (LHG-LGH, QRT-QRT or QRT-QRT).
But never do it with different antenna

5

Hi,

Sadly no.

6

Make sure you use the settings that were successful for you, but are compatible with both devices.

7

That should work just fine, could you post WLAN config’s export from both devices?
The link is either misconfigured or there are some hardware-related issues.
Regards,
M.

8

Hello,
MASTER CONFIG

interface wireless
set [ find default-name=wlan1 ] antenna-gain=0 band=5ghz-a/n country=no_country_set
disabled=no frequency=5440 frequency-mode=superchannel mode=bridge radio-name=
DYNADISH-MASTER scan-list=5400-5600 ssid=FAUCO0021 station-roaming=enabled
wireless-protocol=802.11

SLAVE CONFIG

interface wireless
set [ find default-name=wlan1 ] antenna-gain=0 band=5ghz-a/n country=no_country_set
disabled=no frequency=5440 frequency-mode=superchannel mode=statiojn-bridge radio-name=
LHG5-SLAVE scan-list=5400-5600 ssid=FAUCO0021 station-roaming=enabled
wireless-protocol=802.11