Hey,
I have a MT 3.6 box installed on our main internet line, i have 2 NIC’s in it which are bridged and it works fine, trafic flows in 1 NIC and out the other without any problems.
If I put torch on the interfaces I can see all the traffic flowing thru the NIC’s but if i try and make a Simple Queue to limit an IP it doesnt “catch” the traffic
Is there anyway to setup a queue like this? I’ve tried packet marks in both ip firewall filter and bridge filter, the bridge filter will mark the packets but even a simple queue based on the packet mark wont show up
Merry Christmas