RB1100 jumping to kernel code

Hardware MikroTik hardware general
1

I have the message on console jumping to kernel code
After reinstall via netinstall, it start to work, but, they show me it again when i switch power off and then again power on
After each installation, if i do only the reboot command, it start very nice. But in any time when i do the power off/on, it not start, coming only the message jumping to kernel code, and after some period try reboot again. I change the RAM, but it not help.
the voltage show 12,5V is it nice? May be change the PSU?

2

Can you test memory in BIOS? Hit any key and then “t”

3

try to change boot order.. i dont remember exactly but there are some options for boot ordering..

here is mentioned how to change boot order

http://blog.vodkamelone.de/archives/148-Installing-OpenWrt-on-a-Microtik-Routerboard-RB433.html

4

as i think all tests was done well, because, when it reinstalled via netinstall, and not switch off/on, it work nice.

5

HELL0000O MIKROTIK STAFF!!!

Anybody can help me, 5 days i try to understand what the problem with my newest RB1100, and can’t find solution…
I don’t have the chance to sent it to your dealer, and i see that it really work.

Why after power switching off/on it stop in “jumping to kernel code” section???
And why it work very nice, after reinstalling it via netinstall, until power off/on.
It still work with reboot commands, it work on version 5beta, and 4.11 relaseis only.
with 4.10 it come to “jumping to kernel code” and stop…

6

If you need a reply from the Mikrotik staff you should send an email to support@mikrotik.com. The forums are a community support option and there’s no guarantee staff will ever read your thread.

7

try to install the version you have on other RB(you use RB)
if same error so version not good if all work fine the RB not good :smiley: