RB1100 setup RFC

Hardware MikroTik hardware general
1

Hi!

Am currently setting up a RB1100 for the following environment :-

2x FTTH (5mbps each); same ISP; same gateway IP (ISP side); same subnet (dhcp)
4x 52ports gigabit switch
some number of AP (dd-wrt) to configured to a VLAN and hotspot enabled
some number of servers (connected to gigabit switch)
some number of network printers.
users to be congfigured to 2 VLANs

Question:
Bearing in mind 2x switch group (1Gbps to CPU each) and 3 ports (1Gbps to CPU each). Is there an optimum ports usage for my case? If yes, please suggest.

2

I’ve been digging around for this information as well so let me know if you see anything. My setup will simply be having two RB1100’s running in a public firewall utilizing VRRP. No NAT or anything else.