I need assistance to program my 2011 to fit into my existing network. Currently we have a management Vlan10 which I would like to be setup on the 2011 so we can access it through the network on that VLAN only. This would be on the wired side only. It doesn’t really matter but lets say Ether1 would be our interface connecting to the Cisco switch at that location.
The next item is I need to setup 1 wireless SSID which would tag all clients connecting to this on VLAN40. This access is for guest internet only and it would be preferred if we can disable client to client communication on the 2011 as well for security reasons.
My networks is setup as follows. I really just need AP / Bridge mode from what I can tell on the 2011 but every time I think I’ve got it, I break something else or it doesn’t work completely. I see several chats about pieces of this but not the whole setup so I’ve tried to add interface vlans, interface bridge and tie them together but I’m missing something along the way.
RB2011
|
Cisco 2960 (Port facing RB2011 setup as Trunk allowing both vlan 10 and vlan 40. Can setup native vlan to tag untagged inbound traffic if that makes it easier to setup the RB2011.)
|
|
Cisco Router (DHCP, GATEWAY)