RB3011

RouterOS General
1

Hello

I have install a RB3011 with OS 6.34.3.
My configuration is the following
ether1 management
ether2 LAN1
ether3 LAN2
ether4 LAN3
ether5 LAN5

ether6 WAN1
ether7 WAN2
ether8 WAN3
ether9 WAN4

My external IP´s look like this WAN1 111.111.111.1, WAN2 111.111.111.2,WAN3 111.111.111.3,WAN4 111.111.111.4
Gateway is 111.111.111.6

Now i have configured that LAN1 goes out to WAN1, LAN2 to WAN2, LAN3 to WAN3, LAN4 to WAN4.
My configuration works, but it´s not possible to ping from any of the LAN to WAN. I only can ping directly from the RB.
But my problem is the ping responsetime that is between 500-600ms. When i perform a speedtest is the down ~ 9000 an the up ~ 200. The down rate is ok, but the up is tho low. my ISP is 10/1 MBit.

Have anyone an idea who to fix this

thanks bernhard

2

Hi,

is all your wan IP’s in the same subnet?

If so that may be the issue because MT creates a automatic route when you add a ip.

IF you have 5 IP’s on different interfaces on the same subnet then there is a problem.

Also is the same 4 wan ports connecting to the same physical gateway device?

3

Hello

my wan address are all in the same subnet.
can you give me an info who the rules must be

thanks

4

i have change that all the wan addresses to one interface but it also not working.