RB433 100k barier on wireless

RouterOS Wireless Networking
1

Hello,

in first configuration we had PC with MT OS 2.9.38 on CF card. We where using TP-link 651G as wireless interface and 8139 ethernet intarface. wlan1 and ether1 where in bridge and guy on which roof was AP is conected to ether1 and other users are conected on wlan1 (7 hosts). These are results:

dc++ | wlan user to ether user 10 Mbit
dc++ | wlan user to wlan user 8 Mbit

last week we bought RB433 because PC was crashing and we decided to reniew our configuration. Antena is same, position is same, cable length is same. RB433 is with R52 adapater, OS 3.1, again wlan1 and ether1 are in bridge1 but results are catastrofical.

dc++ | wlan user to ether user 14 Mbit
dc++ | wlan user to wlan user cca 100 kbyte/sec ( +/- 60 kbyte/sec )

what is going on, is there something in Router OS version, some predefinied firewall stuf or enithyng??

sory on my english :slight_smile:

2

It’s strange.

Use ROS 3.22 and let’s see if it solves the problem.

3

At last we upgraded to 3.22 but still 100k barrier.

IS there anyone with same problem?

4

Is the RB433 running as an AP? Are you sure you are running on the same frequency as before?

Look under status at the CCQ and see what kind of error rate you have.

Tom

5

Ofc. it is in AP and it is same freq! We are suspicious about R52 adapters which are 65mW insteda tp Link 100mW, is this justifed?