RB5009UPr+S+IN - Eth2 status LED not working

Hardware MikroTik hardware general
1

I have RB5009UPr+S+IN with PoE AP connected over Eth2. The AP works fine, but on the router only PoE light (orange one) of Eth2 is on, the green light is off. If I move the AP to any other port, the green LED lights up. I’m not sure if it’s been like that since I got the router, but I doubt it (I think I would’ve noticed). I updated the router to RouterOS 7.10.2 along with matching RouterBOARD FW but the problem persists. Is there a chance it’s a software problem or is the LED just dead?

2

Unplug your router of power. Then, plug the router and all leds should turn on. If you see that keeps off, it’s dead.

Regards.

3

Only PoE orange lights (on all ports) light up for a split second when plugged in. Status lights do not light up on any of the ports.

4

Ok, this model is different. And if you put it on Netinstall mode and try to plug in on different ports, no change?

Regards.

5

I just net installed it and no change, so I guess the LED is fried. Thank you for help