RB532 WDS and SR2 and SR5 cards

[Hydro]

I’ve found that when trying to do dynamic WDS with SR2’s and SR5’s and then putting them under a bridge running RSTP it will show the card as being a disabled port. Everything works with CM9 just fine.

I’ve tried 2 different pwr. supplies that are rated at 3amps.
I only run with 1 card(thats all I need).
I’ve tried with both 2.9.23 and 2.9.24

Any ideas?

[cibernet]

@Hydro

I’ve found that when trying to do dynamic WDS with SR2’s and SR5’s and then putting them under a bridge running RSTP it will show the card as being a disabled port. Everything works with CM9 just fine.

I’ve tried 2 different pwr. supplies that are rated at 3amps.
I only run with 1 card(thats all I need).
I’ve tried with both 2.9.23 and 2.9.24

Any ideas?

The port is disabled because the interface is not RUNNING.. (it’s not associated with another card)…

Regards

[Hydro]

I can’t belive I was that stupid, time to stop the coffee and get some sleep like normal people.

Thanks

[snewisp]

Dont feel too stupid, I did that one late night too

Ray