RB750UP and RB600?

0ldman · December 30, 2012, 9:30am

I’ve got an RB600 with two R52H cards that I need to be able to remotely power cycle.

Can the RB750UP handle an RB600 with two cards? It is around a 200ft ethernet run.

onnoossendrijver · December 30, 2012, 11:59am

The RB600 is an 802.3af (48 volt) PoE device. The RB750UP is a 24V passive PoE device… You cannot power a RB600 with a RB750UP.
Don’t you have access to the CLI/winbox of the RB600?

honzam · December 30, 2012, 1:39pm

rb600 - input poe voltage 36-56V

rb750UP have only 24V POE out

jcem · December 30, 2012, 5:29pm

Hi!

I might work, but your cable is long and you have 2 hightpower cards total of 11W ≈ 0,5A on 24V

The powerjack accepts accepts 10-56V

If you use an POE-extractor and plug into the powerjack
https://www.wintherwireless.se/poekit-v2-1xinjector--1xextractor-w-dcconnector-for-ipcam-p-807-c-224.aspx

I have done this with success, but shorter cable

RGDS
Jörgen

honzam · December 30, 2012, 7:20pm

rb600 = 9W

2x R52H = 4-5,2W

totaly with cards 13-14,2W it is on 24V = 0,59A

RB750up have 1A per port. It can mayby works Problem can be lengs of cable.

upgrade firmware on rb750up to version 2.0
http://wiki.mikrotik.com/wiki/Manual:PoE-Out

Good luck

0ldman · January 2, 2013, 5:59pm

Thanks guys.

Yes, the RB600 can take 10-56V, currently running through the jack on 24v since lightning damaged POE port. Still powers on throughy it, but no data.

I was hoping to read that someone else had already done this. Looks like my replacement AP will be here soon enough.