Hello, after using a RB2011 for several years I just received my new L009UiGS-2HaxD-IN (L009). I did not started it for thew first time but my Question would be: Can I update to the latest ROS Version or should I update in several steps - regarding to the factory installed Version? Second Question…

Hey DocSledge, You can safely update your L009 directly to the latest ROS version — no need for step-by-step upgrades unless it’s running a really old factory build. I’d still recommend backing up your config before proceeding. As for expanding your network, connecting the RB2011 as a secondary de…

Good morning to the Board. So after trying for ours I found out that not the wifi-interface is the problem: When a client tries to connect there is traffic shown on the wifi-interface. I am pretty sure that the dhcp-server does not assign ip-adresses to new clients. How did I found out: All my clie…

You probably saw no prompt for the address pool range in the wizard because your IP subnet is specified as /32. Is that intended for the bridge br_lan? If not, and if what you wanted was /24, then modify the /ip address entry for br_lan to have 192.168.179.3/24 as address (instead of just 192.168.1…

[quote="CGGXANNX, post:17, topic:265888"] CGGXANNX - you helped me out. DHCP Server is assigning Addresses, but I don´t have access to the internet, probably of a missing filter rule. For now I only assigned some basic rules for securing the router. Here is the export: /ip firewall filter add actio…

If that's all what you have under /ip firewall, which means you have nothing in the NAT table /ip firewall nat, then it's normal that you cannot access the internet (missing NAT masquerade rule). Also, the filter table that you posted above is unfortunately insecure, due to the presence of this rul…

Rule #8, just in case : [image] The twelve Rules of Mikrotik Club Beginner Basics Preamble and disclaimer: The following is a set of Rules that are intended as advice useful to avoid the most common errors observed in configuration posted on this forum. It is…

Thank you for coming back. I already knew the 12 rules and I might have forgotten to mention that I don´t use the default rules. Masquerading in NAT is enabled. Every client in the Lan-Bridge exept the WIFI-Interface which is part of the Lan-Bridege has access to the internet, all RPI are availabe t…

It is normally a /24, but your entry has the added netmask=24 so I wonder how (the heck) you managed to get that entry, maybe by editing a pre-existing entry? I would remove it and then re-add it as follows: /ip dhcp-server network add address=192.168.179.3/24 dns-server=192.168.179.20 gateway=192…

[gerd@RockfishRouter] > /ip dhcp-server network add address=192.168.179.3/24 dns-server=192.168.179.20 gateway=192.168.179.3 failure: invalid network I'm goin nutz...

In DHCP server network settings, property address has to be a network address, like this: 192.168.179.0/24 . This setting has nothing to do with neither gateway nor DNS server nor DHCP server address ... it has to be network address. If there are multiple DHCP-server network lines, then this is a m…

Router OS Update Question

RouterOS Beginner Basics

jaclaz October 29, 2025, 9:47am 20

Rule #8, just in case :

Once you have done the changes CGGXANNX, please post your COMPLETE configuration (anonymized if needed) for review, going by snippets is more complicated and often unproductive.