i have two boards of this kind the RouterBOARD 133C3 i have some question’s about them can i power them up through poe they only have one lan port if i can then how can i feed in data to the board does this board RouterBOARD 133C3 use 12 volts or 5 volts because i used output: +5.1v= 2.0A would that burn my board can some one tell me the exact power voltage’s for the board so don t end up low powering it or burning it can i access the board without a wireless card on it if yes can you please tell me the deafult ip if no after i put a 2.4ghz card what would be the deafult ip and do i login through winbox?
Your poe adaptor should have a ‘power+data’ port as well as a ‘data only’ port. Connect your pc to the data only port and your RB to the power+data port.
Supports 9-30volts. I recommend at leats 12volts - up to 18v if you’ have a long cable run.
Yes you can, as alluded to above.
After you put a wireless card, by default the wlan interface will be disabled. With or without your wireless card installed, using winbox for initial config, you don’t need an ip - browse for your RB and use mac address; defualt login=admin leave password field blank. Just for information, default ip is usually 192.168.88.1 on ether1 (lan port).
well i can use a 12 volt adapter one two i have a poe that has 12 volt in put and removes 48v that i can t use and u mean i shuld tke the mac of the board and put enter in winbox then it will log me in to the board i have 2 sector anntena’s and 4 mitrotik boards two big two small i have a vsat pumping in internet i want to pump it into the mitrotik boards and broacast through my sector anntena’s and have sum omin anntena’s to 2.4ghz i wana make a small network but need help on how to config on the winbox ?
i have just downloaded a pdf file of MikroTik RouterOS™ v3.0
Reference Manual
is this a operating system i have to install and use as a server or is it just a reference manual of winbox ? can i run all my anntenna’s through winbox without having a server and making winbox do everything bandwith control firewall user name passwords for clients if a user goes over his limit putting him bck to his limit like if a user is using alot of bandwith his given 10 kbps and he uses 20 bringing him bck to 10 is tht possible also can i remotely login to all my routers? and check who’s logged on to which ap what time etc