RouterBOARD 433 + R52NM x2?

Hardware MikroTik hardware general
1

Hello!

I am about to setup a wireless network in a tower that is going to distribute internet and LAN to about 5 houses around it and for that I wanted to go with x2 R52NM on a simple RouterBOARD 433 (300MHz CPU). Is this possible or is the CPU to weak to even make a stable bandwidth of 50mbit/s?

That main thing is that I need a RouterBOARD with 2 radios that has the 802.11n standard @ a low cost!

All information and advice is highly appreciated!

Best regards,
Mattias

2

If at least one client will be with bad wireless signal, you might need that higher CPU.

3

Thanks for the reply!

Why whould the wireless signal matter? :open_mouth:

4

Bad signal results in retransmits and delays, so some of the packets will need to spend more time in buffers/memory, that usually results in higher CPU load

5

Ah okey..

I think I will try this out, but I will lower the bandwidth so the CPU can handle it. It should at least handle around 30MBit/s!?

Regards