routing

[oxid]

hi all

This is my first on this site please help me this subject
As shown in the picture attached

My request is about how to prepare Router Board 1100
To direct Internet addresses of the ports shown pictures
Data:
Gateway: 192.168.1.49./28
how to get 192.168.1.50 over ether2

192.168.1.51
192.168.1.52 over eth3

192.168.1.53 eth4

192.168.1.54 eth5

[Letni]

This sounds more like a switching setup then a routing one.
In my experience the upstream provider will assign you a /30 for your internet side and route an additional /28 to your router where then you can break it up as needed. Sounds like you need to just set it up as a switch and assign static IP’s to your devices.

If the diagram is really what you want then I think you are looking at doing 1-to-1 NAT.
Here is some documentation on it. http://wiki.mikrotik.com/wiki/Manual:IP/Firewall/NAT#1:1_mapping

-Louis

[oxid]

@Letni

This sounds more like a switching setup then a routing one.
In my experience the upstream provider will assign you a /30 for your internet side and route an additional /28 to your router where then you can break it up as needed. Sounds like you need to just set it up as a switch and assign static IP’s to your devices.

If the diagram is really what you want then I think you are looking at doing 1-to-1 NAT.
Here is some documentation on it. http://wiki.mikrotik.com/wiki/Manual:IP/Firewall/NAT#1:1_mapping

-Louis

thank you so much
but what

gateway and routing?