hi, anyone using S-3553LC20D with fiber drop cable (fast connector ?
as i see the rx sensitivity is -24 dBm.
drop cable usually can maintain around -19~ -21 dBm.
attenuation always depends on type and length of the cable. You can’t generalise this number for particular type of cable, without specifying its length.
To sum up, there is simply no “support or does not support” - any cable is supported, as long as it transfers the signal without extensive attenuation.
And since everyone uses installation of different length, you can’t simply get any relevant info.
I am sure you correctly realised that with -24dBm sensitivity and -3dBm maximum output power, you have maximum allowed loss of -21dB on cable+connectors.
If your particular cable installation has -19dB to -21dB loss, then I would say there is very low margin for an error and you might experience troubles.