Setting Mikrotik as a Switch

RouterOS General
1

I’m trying to setup a Mikrotik RB751 as a switch.

Initially I have ethernet port 2 connected to the uplink LAN and configured inside a bridge toghether with wlan1 .

When configuring ehthernet interfaces 3 and 4 as slaves of interface 2 (modifying the master-port to ethernet 2), the ping stops responding.
Setting those interfaces back to NONE, enables the ping response once again.

The interface ethernet 2 has an IP assigned wich is the one that responds to the ping.

Which would be the correct way to configure the router as a standard switch?

Thanks

2

if you are bridging, you should set the master as the bridge not the eth2 port

also only the bridge should have an ip, none of the interfaces