Setting Up Two LANs on MikroTik L009 Router

[Buckeye]

How will guests and customers be accessing LAN 2 (192.168.20.1)? wired, wireless, both?

Go review responses to your previous threads. There were thoughtful responses from @anav @Sob @sindy @mkx covering firewall, vlans, etc.

drop traffic between interfaces without using VLANs

Hello my friends..!. Hope you are all doing good.. So i have this situation. My mikrotik router 951ui have 5 interface Eth1. The WAN interface with the ip 192. 168.134.2/30 Eth2. The camera interface with the ip range 192.168.10.1/24 The dhcp is enable on this interface and there is a src nat rule to The out interface 192.168.134.2 so it has internet access. Eth3. The pbx interface with ip range 192.168.20.1/24 also it has internet access and dhcp enable. Eth4. The data interface with i…

separate two interface in same router using VLANs

Hello for all …! so i see a lot of video out there talking a bout VLANs and How to setup VLANs , but all this video talking about VLANs in two or more device, So what if i have only one MT router and i want to separate eth3 and eth4 forexample using VLANs what i have to do in this case..? anyone try this ..? or it’s a mendatory to have to connected device so we have trunk and access port..? in my single router VLANs scenario i want only access port so no trunk port, also the two access port ha…

Issue with VLAN Configuration in a Critical Environment

Hello everyone, I am trying to create a VLAN using a Mikrotik CCR2004 Router and a CRS326 switch, but I’m unsure about the correct approach given my specific scenario. I have two public IP addresses: one for the LAN (WiFi, cameras, etc.) and another for the server. I want to completely separate the LAN from the server. Here is the VLAN configuration I’ve set up -( you can see the attached file for both Router and switch)- Is this setup correct? As you can see, the server network is on VLAN 10…