SFP-10G-LR Doesn't work on CRS

Hardware MikroTik hardware general
1

I have tested and discovered that SFP-10G-LR SFP+ modules don’t work with the CRS226 series switches.

Keefe

2

Hello,

I am currently using a SFP-10G-LR in a CRS226, linked toward a CCR. This setup has worked fine the last 6-8months.

The SFP+ is a Fiberworks module, but is Cisco coded(was originally supposed to be used in a Catalyst 4500-e switch), but works fine with all Mikrotiks I have tested it with.

Regards

3



Please post printouts from commands:

/interface ethernet print detail where name~"sfp"
and
/interface ethernet monitor (interface)
4 
[admin@ehq-sw1] > /interface ethernet print detail where name~"sfp"
Flags: X - disabled, R - running, S - slave 
 0  S name="sfpplus1" default-name="sfp-sfpplus1" mtu=1500 l2mtu=1588 mac-address=4C:5E:0C:9B:C4:DE 
      orig-mac-address=4C:5E:0C:9B:C4:DE arp=enabled auto-negotiation=no 
      advertise=10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full full-duplex=yes tx-flow-control=off 
      rx-flow-control=off speed=10Gbps master-port=ether1 bandwidth=unlimited/unlimited switch=switch1 
      sfp-rate-select=high 

 1  S name="sfpplus2-gfs-xe" default-name="sfpplus2" mtu=1500 l2mtu=1588 mac-address=4C:5E:0C:9B:C4:DF 
      orig-mac-address=4C:5E:0C:9B:C4:DF arp=enabled auto-negotiation=yes 
      advertise=10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full full-duplex=yes tx-flow-control=off 
      rx-flow-control=off speed=10Gbps master-port=ether1 bandwidth=unlimited/unlimited switch=switch1 
      sfp-rate-select=high 
[admin@ehq-sw1] > /interface ethernet monitor sfpplus2-gfs-xe
                      name: sfpplus2-gfs-xe
                    status: no-link
          auto-negotiation: done
               advertising: 
  link-partner-advertising: 
        sfp-module-present: yes
               sfp-rx-lose: yes
              sfp-tx-fault: no
        sfp-connector-type: LC
       sfp-link-length-9um: 10000m
           sfp-vendor-name: OEM
    sfp-vendor-part-number: SFP-10G-LR
       sfp-vendor-revision: A
         sfp-vendor-serial: CLS10281932
    sfp-manufacturing-date: 14-01-10
            sfp-wavelength: 1310nm
           sfp-temperature: 44C
        sfp-supply-voltage: 3.348V
       sfp-tx-bias-current: 0mA
              sfp-tx-power: -7dBm

Here’s one side. I have to get the other in a little bit.

5

In printout we can see that module for some reason ain’t receiving incoming signal from device that is connected on the other side. Printout from other device could probably show more. Also please mention what device model you have on the other side of link.