Simple Queue bandwith control problem on 6.37.3

RouterOS General
1

Hi to all, i really don’t know if this is the right place to post this, please correct me if it is not… i would like to report a problem that i found with last version 6.37.3.

The problem is that when i have simple queues, there is not a real bandwith control. When i see for example 20Mbps of download rate in the PPPoE interface, at the simple queue the parent queue says that are 300Kb of download rate. This problem fixes when i run a Torch on the LAN interface. While Torch is running, queue works fine… When torch stops, queue have mistakes.
This problem i have with a lot of Hex and Hex-Lite with 6.37.3 firmware.
This same config on a 6.37 firmware on X86 works fine. and is the same config that i have been using for years, always working fine.

I already made a video, so you can see the problem, and a supout.rif file if you need it.
https://www.youtube.com/watch?v=SZDr4zIqynI

(i can’t attatch the supout.rif file to this post…)
Thanks in advance. Kind regards

2

Switch the fasttrack off.

3

Hy Jarda, thanks for your reply. your are right, disabling ip-firewall-fllter rules “Fasttrack-Connection” rule, the problem solved.
Now all works fine. Thanks for your help.

Kind Regards and happy new year.

4

Guys,
I am also facing this same issue on my Router,
I have two Router Mikrotik, one router i have two ISP lines 100MB and getting 200MB Output by marking it in Firewall ,From this router output is 200MB.

on the other router my WAN is at 130 MB and rest of 70MB is not shown anywhere.
I have also these fast track dummy rules. Help me in this regard. I tried to check all rules by disabling them on Firewall Mangle, and Queue Tree but nothing any improvement.

5

How to switch off the fast track rules.

6

Delete or disable them.