Greetings,
I am new to MikroTik, but learning quick, but not quick enough.
I need to deploy this unit fairly quickly for a down customer.
I have a RB/411 with a R52H wireless card. ROS is 3.10.
This unit is a CPE configured in NAT mode. public ip is 12.197.10.203 and the
private is 192.168.14.1. It is configured as a DHCP server for the private network.
The problem is if I ping a new address on the Internet pass the Cisco router,
it takes between 15 seconds to 5 mins to start the ping.
Once the ping is started all works fairly well. If I ping an address on the LAN it is happy.
NAT:
Flags: X - disabled, I - invalid, D - dynamic
0 chain=srcnat action=masquerade src-address=!12.197.10.203
out-interface=!ether1
print
Flags: X - disabled, I - invalid, D - dynamic
ADDRESS NETWORK BROADCAST INTERFACE
0 ;;; added by setup
192.168.14.1/24 192.168.14.0 192.168.14.255 ether1
1 ;;; added by setup
12.197.10.203/27 12.197.10.192 12.197.10.223 wlan1
Not sure what else I need to add to the message.
Suggestions?
thanks
Darryl Wagoner DE WA1GON
Mason Internet COOP
I fixed the problem by start from scratch. Don’t know what I did different, but all is well.