SNMP service problem?

rastod · July 5, 2005, 9:09pm

Does SNMP service works on 2.9rc6 ? I am not able to read from MT any data. There was no problem on 2.8 .

changeip · July 5, 2005, 9:45pm

Working fine here … at least for reading interface values. Not sure about other OIDs. My MRTG graphs are still reading in/out values for the different interfaces though.

Sam

rastod · July 5, 2005, 10:15pm

Yes, it works !!!

I am connected through PPPoE tunel to the MT and when trying to read SNMP from PPPoE connection, it does not work. When trying to read SNMP from “outer” network, it works. Is it possible?

changeip · July 5, 2005, 10:47pm

Does your input chain allow snmp access from pppoe interface?

Sam

rastod · July 6, 2005, 4:44am

I have no filter defined on firewall

sergejs · July 6, 2005, 7:19pm

There is new feature in 2.9, “tool graphs”.
It works similar
It is easier in configuring, and web checking also available, by router_ip/graphs.

rastod · July 6, 2005, 8:44pm

it is not good solution. Why it does not work?

sergejs · July 6, 2005, 9:00pm

Why it is bad ?

This thing should be tested.

changeip · July 6, 2005, 9:41pm

Is the interface you are querying a dynamic interface? You should always query a static interface / ip on the mikrotik for snmp - snmp service might not bind to changing ip addresses. Also, you might be able to setup a redirect rule to make it work, however querying the permanent interface address should work fine. It works here with no problems on rc6.

Sam