Superchannel AP BRIDGE + NanoStation2 Client

RouterOS Wireless Networking
1

Hi

I have a rb333 + superchannel licence, use a Wireless Interface in 2.377Mhz AP Bridge mode

In my cliente, have a NanoStation2 new firmware open a 2.3 frequency Client Mode

and not works

any have idea 4 this???


tks

2

If you don’t see AP on MikroTik device. It’s clearly problem of the client device and you have to look where is the problem with used client device.

3

did you try on another frequency? on RB333?


because the NS2 you have to put on compliance test.. and is 2.3 - 2.6 ghz

4

… also check, if the NS2 has frequency shifting enabled.

5

in 2377Mhz the signal will be lower than 2457 (exemple). Make sure you have enough signal.