Configuring wlan1 2,4 GHz to link manage?
For I set up and it did not work …
Please post your configuration. Is it in ap-bridge mode?
Not supported?! 
Yes, The device license is not enough (Level3)
Set it to bridge, one client is allowed
Gesendet von meinem HTC Flyer P510e mit Tapatalk 2
WPA2: /interface wireless security-profiles add name=WPA2 mode=dynamic-keys authentication-types=wpa2-psk unicast-ciphers=aes-ccm group-ciphers=aes-ccm wpa2-pre-shared-key=“ZW78sgOr”
AP: /interface wireless set wlan1 mode=bridge band=2ghz-onlyn channel-width=20mhz frequency=2412 ssid=“SL-M” wireless-protocol=802.11 security-profile=WPA2 frequency-mode=superchannel country=no_country_set default-authentication=no default-forwarding=no hide-ssid=yes rate-set=configured supported-rates-b=“” basic-rates-b=“” supported-rates-a/g=“” basic-rates-a/g=“” adaptive-noise-immunity=ap-and-client-mode ampdu-priorities=0,1,2,3,4,5,6,7 ht-supported-mcs=mcs-5,mcs-6,mcs-7 ht-basic-mcs=mcs-5 disabled=no
Station: /interface wireless set wlan1 mode=station-bridge band=2ghz-onlyn channel-width=20/40mhz-Ce ssid=“SL-M” wireless-protocol=802.11 security-profile=WPA2 frequency-mode=superchannel country=no_country_set rate-set=configured supported-rates-b=“” basic-rates-b=“” supported-rates-a/g=“” basic-rates-a/g=“” adaptive-noise-immunity=ap-and-client-mode ampdu-priorities=0,1,2,3,4,5,6,7 disabled=no
default-authentication=no
Also check the logs.
The MAC has already released
Access List:
/interface wireless access-list add interface=wlan1 mac-address=6C:3B:6B:10:39:76 forwarding=no comment=“Lua_STA-ac”
I found thought it was to make a link in 2.4GHz to manage the way to 5.8GHz but has no 2.4GHz antenna could only connect to the SXT near her …