SXT led

Hardware MikroTik hardware general
1

Hi All,

I recently bought 2 new SXT devices. Both upgraded to the latest 5.7 release and configured in station mode.

I was surprised when I noticed that after binding to the AP, none of the led indicators were operate (on both of them)! :confused:

I tried using led on/off commands (:led user-led=no ; :led user-led=yes) but nothing happened.

Furthermore both sxt operate normally in station mode in terms of connectivity and data exchanging.

Any ideas?

It’s bizarre because same behavior depicted for two separate devices in the same time.

No similar incident noticed with other sxt devices purchased so far.

2

Update.

I think this issue resulted due to v5.7 update. There is a slight difference between v5.6 & v5.7.

v.5.6
v5.6.jpg
v5.7
v5.7.jpg
What is this unknown value inlaid?
Is this a sw bug or a new design for v5.7 release?

3

please make a supout.rif file when the device is it in this problematic state, and send to support.