The THING!

Hardware MikroTik hardware general
1

Few days ago one of ours 5GHz ap-ap link was bad (ccq 80%/90% but ping and bandwidth awful). On one side we changed all but antenna and that link is now fine. But!

On that new rb433AH there is another card that acts as 2.4GHz AP for around 30 clients. That link is now baaaad! (ccq again +80% and signals around 60-70 but clients rate is now 2/11).
Tried with mt upgrade to 3.24, few different types of cards and slots.

If there is no traffic pings are superb, but if there is around 1meg of traffic ping goes to 700-900ms. Before we changed rb that ap worked fine.

Any ideas???!?!?!
mt.JPG

2

c’mon mtikers help your licensed user.

3

change the speed to Only G and 24mbps. Why do you use B only? Never worked for me.

4

and disable all of the B rates on the radio. otherwise B devices nearby will still screw with your AP (tested on numerous indoor applications where the MT AP was installed nearby an older B only AP that was going to be replaced, MT could not hold clients even when on non-overlapping channels.)

5

Only G means only G and not B/G & stuff…

6

will try