Too stupid for VLANs!

RouterOS General
1

Hi there!

I’m replacing my unmanaged D-Link 24 port switch and MT 2.8 with a Linksys srw224g4 managed switch and MT 2.9
So far, so good, but my target is or was to configure every port on the switch as a seperate VLAN (101 - port 1, 102 - port 2, …) and attach it via the gbit uplink to a intel gbit nic in the MT.
My config was all ports Access Ports with the matching VID and the gbit Port as a Trunk port (tagged). I added the VLANs to the interface of the MT Router and wanted to test it… absolutely nothing worked! No ping, nothing.

Is there anything else I have to do?

Thanks and have a nice day,
uebi

2

i’m not familiar with this linksys switch but does it perform 802.1q type tagging?
do you by any chance bridge the parent (gbit) interface?

3

Hmm, started from the beginning, updated the firmware of the switch and used my brain a bit more - now it works!

I should have been starting over before wasting 3 hours… G


Thanks,
mfg uebi