Torch not show all traffic on interface???

RouterOS General
1

Hi all,

I’m using MK CCR1036 with 02 SFP+.

Bandwith I see on interface SFP+ about 800Mbps.

But when I use torch, it’s shown ~200Mbps only.

How can I optimize to torch can show all traffic on interface.

Thanks,

2

While Torch is running is reported speed on interface still 800Mbps or it drops to 200Mbps also there? Torch disables FastPath:
https://wiki.mikrotik.com/wiki/Manual:Fast_Path

3

When I run torch, it just show 200Mbp only (instead of 800Mbps).

My ROS is v6.27, as far as i know, this version (6.27) not support FastPath yet.

4

FastPath was already supported then. Maybe you confused FastPath with FastTrack:
https://wiki.mikrotik.com/wiki/Manual:Fast_Path
https://wiki.mikrotik.com/wiki/Manual:IP/Fasttrack

5

@: Strods: Thanks for you info,

So, how can I configure to monitor all my traffic?