two IPs for the same MAC on IP Pool used address

RouterOS General
1

Hi,
I am using a RB993 as a hotspot gateway and user authentication, and when I do the setup for my hotspot, the pool is generated, so I use this pool on the user profile too.
The problem I have is that on the IP, Pool, Used address, I have two IP address for the same MAC.

So my question is; Should I use the same Pool Address on the server and user Profile?, or any suggestion on what is the best configuration?

The scenario of the use of my hotspot
I have a RB493, as a hotspot Gateway, on port 5 I have a ubiquiti Access Point Rocket M
On the customer side I have Nanostation M5, configured as router, getting DHCP from the Hotspot.

What I am looking is to have always the same IP asigned to the CPE (Nanostation M5), but only one not two.

Thank you in advance for your time giving me some advice.

2

Set the address pool on the Hotspot server profile to ‘none’.

3

Thank you Fewi, :smiley:
I did the change, but just another question, this change is only on the

Hotspot server

or also on the

Hotspot user profile

?.

Thank you for your help
Best regards

4

In “/ip hotspot” the address pool should be set to “none”, often this is filled out by the wizard to a pool name. In “/ip hotspot user profile” the address pool should be set to none if you manually defined one. In “/ip hotspot user” the address should be empty or set to 0.0.0.0 if that is filled out.

5

Thanks a lot, Fewi :smiley: .
Now my Hotspot is not assigning new IP just take the one that was assigned by the DHCP, and from my management system I can know the IP that the devices I am managing has all the time. excellent help!!!.
Best regards